Panasonic PV-8665S - Manual (Page 18)

On-SCTeei^isplay^OSD)
*lmportant: tf the remote control POWER, ACTION, PROG, CHA/T, INDEX or ADD/DLT button does
not work when pressed, press the VCR button on the remote and try the button again.
Function & Channel Display
When a function button is
pressed, e.g. PLAY, or
you change channels,
a 4 second display
appears first in large
and then small characters.
(Some Station names may
also appear if Channel
Caption is set. See pages 28, 29.)
Menu Screen
1 Press ACTION* to
display the menu.
2 Press
AT
and ^ to
make your selection.
SET UP VCR
SET UP FEATURE
imigga
SET UP CHANNEL
IDIOMA/LANGUE: ENGLI SH
SELECTiA T KEY
SET :► KEY
END
:ACT I ON KEY
To get the most from each feature,
please read the Operating Manual
before attempting any operation.
VCR Status & Clock Display
Press DISPLAY to dispiay or remove the
overlay shown below.
Current Time
Function
Status
Rec Time
Remaining
(OTR mode only
see page 20.)
Channel Caption
(See pages 28, 29.)
REC 12:00AM ABC
0:25 -0:12:34
► STEREO SP
► SAP
MONO
Broadcast Audio
Being Received
(See page 32.)
• This display will
disappear in 5 seconds.
Counter
Tape Speed
(See page 5.)
Blank Tape/ No Video Signal Indication
Whenever a blank section of a tape comes up in Play
mode, or when the selected channel has no broadcast
signal with the Blue Back ON/OFF Feature (page 30)
set to ON, the TV screen will turn solid blue.
Warning and Instruction Displays
These displays will alert you of a missed operation or
provide further instructions.
If no active channels are found
for CHANNEL MEMORY...
(See page 16.)
If you attempt to set or review
a Timer Recording and the
Clock is not set...
(See page 22.)
After a Timer Program has
been set...
(See page 22.)
If you press REC on the
remote control or VCR,
and a cassette is inserted
with no record tab...
(See page 20.) '
If you press PLAY, FF, REW,
or REC on the remote
control or VCR without
a cassette inserted...
(See pages 19, 20.)
If you press POWER or STOP
during a Timer Recording...
(visible in VCR mode only)
(See page 23.)
If head cleaning becomes
necessary while playing
back a tape...
(See page 5.)
If you press a function button
other than STOP/EJECT or
POWER on the VCR, or STOP
or EJECT or POWER on the
remote control while the VCR is
in VCR Lock mode...
(See page 27.)
If you press POWER, ACTION
or PROG on the remote white
in TV or CABLE/DSS mode...
(See pages 36, 37.)
NO CH FOUND
PLEASE CHECK ANTENNA
CABLE CONNECTION THEN
PUSH VCR CH UP KEY AGAIN
PLEASE SET CLOCK
BEFORE PROGRAMMING
TURN VCR OFF
FOR TIMER RECORDING
AND
LEAVE CABLE BOX POWER ON
CHECK CASSETTE
RECORD TAB
NO CASSETTE
PLEASE INSERT A CASSETTE
TO CANCEL TIMER REC
PUSH POWER THEN STOP KEY
VIDEO HEADS MAY
NEED CLEANING
PLEASE INSERT HEAD
CLEANING CASSETTE
OR REFER TO MANUAL
END:PLAY KEY
VCR LOCK ACTIVATED
NOW TV/CA8LE/DSS MODE
PLEASE PUSH VCR KEY
ON REMOTE
18