Panasonic TX-56P800H - Manual (Page 28)

2Э-ОСТ-2004 13:14 FROM
TO operating instr P.28
ASPECT
Press to select the different Aspect options.
-^AUTO-
- ZOOMS ■
-^16:9 14:9 JUST<-
ZOOM2 ------- ZOOMI ^ 4:3 ^
Notes.
aspect
* Simply press @ to display mode information in the top left of the screen,
* 16:9 picture has been used to illustrate all of the aspet; modes described in this section.
The on screen selector keys (corresponding to the four coloured buttons on the remote control) appear for some Aspect functions and disappear
after a few seconds. If you would like to select an operation when the keys are not shown, press once more and the keys will reappear.
Helpful Hint ([E]Normalization)
By pressing the Normal ‘‘N" Button on the Remote Control while the Aspect menu is displayed, the selected menu will be changed
to the Normal Mode.
Normalization will not occur If the menu is not displayed when the “N” Button is pressed.
The Normal rnode is the factory preset condition. Returning to this original condition is called "Normalization".
Mode Picture Explanation
AUTO
The AUTO position can be set to 16 : 9. When a
wide screen signal is detected at the Video
terminal the TV will select the 16:9 aspect ratio.
16:9 Signal 4:3 Signal
16 :9
The 16:9 option will display the picture at its
maximum size. Signals in the 4:5 format will be
stretched to fit the picture.
16:9 Signal 4:3 Signal
1 4 : 9
The 14:9 option will display a 4:3 signal in
simulated wide screen. The picture i$ slightly
stretched. It is also slightly cropped top and
bottom.
JUST
О
О
JUST gives you a best fit option when showing
4:3 on wide screen. The centre of the picture is
not affected but there is some stretching at the
edges.
4:3
This option will display a standard 4:3 picture
without any stretching or compression. There
will be vertical gray lines down either side of the
picture.
ZOOMI
-£SJ
This option allows you to magriify the picture.
ZOOMS,
ZOOMS
The picture becomes larger and larger when
you change the mode ZOOM2 and ZOOMS.
Notes:
•ASPECT operations cannot be made during progressive (Y, P b , P r ) or 10S0I signal input.
* The Red and Green buttons let you change the mode during the mode displays.
28