A warning, Installation hardware, Overview – Panasonic Removable Full Front CD Player/Receiver with Dot Matrix and CD Changer Control CQ-DFX983U User Manual

Page 50: Required tools, Dashboard specifications, Installation guide

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Installation Guide

A WARNING

This installation information is designed
for experienced installers and is not in­
tended for non-technical individuals. It

does not contain warnings or cautions of

potential dangers involved in attempting

to install this product.

Any attempt to install this product in a

motor car by anyone other than a quali­

fied installer could cause damage to the

electrical system and could result in se­
rious personal injury or death.

□ Installation Hardware

No.

Item

Diagram

Q’ty

©

Mounting collar

1

©

Hex. nut (5 mm^)

1

Rear support strap

1

©

Tapping screw

(5 mm0x16 mm)

1

Mounting bolt (5 mm0)

1

©

Power connector

1

©

Removable face plate

case

1

©

Trim plate

1

©

Lock cancel plate

2

□ Overview

This product should be installed by a professional.

However, if you plan to install this product yourself,

your first step is to decide where to install it. The in­

structions in these pages will guide you through the
remaining steps:

(Please

refer

to

the

“WARNING”

statement

above.)

• Identify and label the car wires.

• Connect the car wires to the wires of the power

connector.

50

CQ;

d

F,X9837DF,903U

• Install the unit in the dashboard.
• Check the operation of the unit.

If you encounter problems, please consult your
nearest professional installer.

Caution:

• This unit operates with a 12 V DC negative

ground auto battery system only. Do not at­
tempt to use it in any other system. Doing so

could cause serious damage.

Before you begin installation, look for the items

which are packed with your unit.

• Warranty Card.

..Fill this out promptly.

• Panasonic Servicenter List for Service Directory

...Keep for future reference in case the product

needs servicing.

• Installation Hardware.

..Needed for in-dash in­

stallation.

□ Required Tools

You’ll need a screwdriver, a 1.5 V AA battery, and
the following:

12 V DC

Electrical

Side-cut

Test bulb

tape

pliers

□ Dashboard Specifications

Thickness Min.

У\4'

{4.75 mm)

__.Ц._ Max. Уэг" (5.56 mm)

W

1

2Vzf

(53 mm)

,7Уз2"(182тт)

Advertising