Panasonic TX-47P600H - Manual (Page 20)

Tuning Channels
Automatic Tune
This TV uses automatic tuning to determine whether or not the TV can receive a broadcast signal which is being sent.
Before Automatic Tune, Regional System must already be set {Refer to pages 19).
1 AUTO TUNE
2 SOUND SYS
STR
Press to select the “AUTO TUNE”.
Press to access to the “AUTO TUNE”.
^ Search Start.
I
MIM c Í l IJI'IIMÍ s
(SYS SELECT AUSTRALIA
rAUTQTUME ■ACCESS
(MANUAL TUNE
(SOUND SYS 5.5 MHz
( COLOUR SYS AUTO
Bmia ■n > "
(SKIP OFF
"► When a station is found.
The best tuning position is automatically
memorized.
After all stations are tuned, the on-screen display will automatically change from “AUTO
TUNE” to “SOUND SYS” Position.
Press to improve the Sound quality, if the Sound
is not clear or no sound is produced on a
programme Number Position.
c
4.5MHz --------- > 5.5MHz
6.5MHz <--------> 6.0MHz
3
Press to store the Sound System.
TUNING MENU '
SYS SELECT
AUTO TUNE
MANUAL TUNE
AUSTRALIA
gnuMn eve
COLOUR SYS
TV/AV
----------------- Press to exit from the Tuning Menu.
This returns the set to the normal viewing condition.
Note:
When the sound volume is too small to confirm, turn it up by using the sound volume button on the remote control.
Under the normal viewing condition press to enter each programme Number.
Confimi the tuning condition.
If necessary, repeat step 2 for each Programme Number.
f'Helpful Hint
(1) If a clear picture with correct colours cannot be obtained when a Broadcast or AV signal is received, refer to the
“Colour System Selection” operation on page 24.
----------- - After the Automatic tune is finished, under the normal viewing condition press this button to
confirm the tuning condition for each Programme Number. If some Programme Numbers are
unused (no TV stations), it is possible to skip such Programme Numbers. Please refer to the
Programme Number Skip operation on page 23.
o
20