Panasonic TX-47P600H - Manual (Page 21)

Tuning Channels
Manual Tune
Before Manual Tune, Regional System must already be set (Refer to page 19).
1 MANUAL TUNE
© Press to select the MANUAL TUNE.
STR
TV/AV
2 SOUND SYS
SETUP
Press to access to the MANUAL TUNE.
Press to select the desired Programme
Number.
Press to select the higher or lower channel.
^ Search Start.
Panasonic
■ i«r PROGRAMME -/+
• SEARCH -/+
RETURN- - TV/AV*-EXIT
‘STR’ BUTTON-STORE
MANUAL TUNE
When a station is found.
When the desired station is found, press to store.
The tuning position is memorised.
Press to exit from the Tuning Menu.
This returns the set to the normal viewing condition.
Press to display the SETUP MENU.
Proceed to the TUNING MENU, and then to the SOUND SYS (refer to page 24).
3 Adjust the Sound System (refer to page 20 step 2 to 3).
f'Heipful Hint
(1) If a clear picture with correct colours cannot be obtained when a Broadcast or AV signal is received, refer to the
“Colour System Selection” operation on page 24.
(2) /---------- r- After the Manual tune is finished, under the normal viewing condition press this button to confirm
the tuning condition for each Programme Number. If some Programme Numbers are unused (no
TV stations), it is possible to skip such Programme Numbers. Piease refer to the Programme
Number Skip operation on page 23.
(3) When using a VCR without video and audio inpuVoutput terminals, it is convenient to connect the aerial cable as
indicated in the instruction manual of VCR and to set the designated channel to programme No. “0”. In that case,
perform manual tune after setting the colour system and sound system in advance. Further, in multi-system VCR,
it is more convenient to set the designated channel to several programme Numbers.