Panasonic TX-47P600H - Manual (Page 27)

Picture Adjustment
C. TEMP
(Colour Temperature)
Set the overall colour tone of the picture.
Press to switch between modes
^STANDARD-^^ WARM ^ COOL
P-NR
(Picture Noise Reduction)
Al
(Artificial intelligence)
Automatically reduces undesired picture noise.
Press to switch between modes
OFF ------ > STRONG
AUTO <---- > WEAK
Automatically analyses the incoming picture
and processes it to give improved contrast and
optimum depth of field.
ON <-
Al
SCAN MODE
P-NR
SCAN MODE
-> OFF
SCAN MODE Choose the screen refresh method:
Press to switch between modes
AUTO -^^100 Hz MODE<-^PROGRESSlVE
3
MODE Function
AUTO The TV software will select the best mode for the signal being viewed.
100 Hz MODE 100Hz will give a steady picture for most signal transmission.
PROGRESSIVE Recommended when receiving NTSC signals.
Switching is also possible using on the remote control.
Note:
We recommend that you set Scan mode to Progressive when viewing a PAL 60 or
NTSC transmission. When viewing a PAL transmission (other than PAL 60) with Scan
mode set to Progressive, the screen will flicker, this is not a fault.
f Helpful Hint (BNormalization)
By pressing the Normal “N” Button on the Remote Control while the Picture menu is displayed, the selected menu will
be changed to the Normal Mode.
Normalization will not occur if the menu is not displayed when the “N” Button is pressed.
The Normal mode is the factory preset condition. Returning to this original condition is called “Normalization”.