Panasonic CQ3700EU - Manual (Page 14)

Installation Guide
A
WARNING
This installation information is designed for experienced instaiiers
and is not intended for non-technical individuals. It does not con­
tain warnings or cautions of potential dangers in attempting to
install this product.
Any attempt to instali this product in a motor vehicie by anyone
other than qualified installer could cause damage to the electrical
system and could result in serious personal injury or death.
□ Overview
This equipment should be installed by a profession­
al. However, if you plan to install this unit yourself,
your first step is to decide where to install it. The
instructions in these pages will guide you through
the remaining steps: (Please refer to “WARNING”
statement above).
• Identify and label the vehicle wires
• Connect the vehicle wires to the wires of the
power connector
• Install the unit in the dash
• Check the operation of the unit
If you do encounter problems, please consult your
nearest professional installer.
CAUTION: This unit will operate with a 12 volt DC
negative ground auto battery system only. Do not
attempt to use it in any other system. Doing so
could cause serious damage.
Before you begin installation, look for the following
items included in the packing with your unit.
• Warranty Card........ Fill this out promptly
• PASC Servlcenter Directory ............... Keep for
future reference in case the unit needs servicing
• installation Hardware........... Needed for in-dash
installation
• Power Connector
□ Installation Hardware
No. Item Diagram Qty
©
Mounting Collar 1
Plain Washer (5 mm<))) 2
Spring Washer (5 mmiti)
2
Hex. Nut (5 mmtt)) 2
Rear Support Strap
1
Hex. Bolt
(5
mm(t) X
25
mm) çf
1
©
Toothed Lock Washer
(5 mm^)
% 1
®
Power Connector 1
@
Dismounting Pin
(U-shaped)
dy
2
14
CQ-3700EU