Infrared data communications, Infrared data communications.40 – Panasonic CF-M32 Series User Manual
Page 40
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Infrared Data Communications
Your computer is equipped with an infrared communication port enabling you to transfer
data without a cable.
1
Set the address of your infrared communications port to
enable
Run the Setup Utility, then set infrared address for [Infrared Port] and set [Dis
abled] for [ASK Mode] in [Supervisor Setup]. (G’pageTS)
2
Install the Windows 95 infrared communication driver
To install the infrared communication driver after reinstallation;
You must insert the Windows 95 CD-ROM (included) after Step
8
.
below.
Therefore a PC Card-compatible CD-ROM drive should be connected. (See the
manual included with your CD-ROM drive for details on how to connect it,)
1. Click [Start], then [Settings], then [Control Panel], Double-click the [Add New
Hardware],
2.
When the [Add New Hardware Wizard] opens, click [Next].
3.
The following message will be displayed: "Do you want Windows to .search for
your new hardware?". Select [Nol, then click [Next],
4.
Under [Hardware types], select [Infrared], then click [Next],
5.
When the [Add Infrared Device Wizard] opens, click [Next].
6. Under [Manufacturers], .select [Standard infrared devices], then click [Next],
7.
In the port selection window, select [Generic Ir Serial Port (COM2)], then click
[Next],
8
. Select [Use default ports], then click [Next].
The infrared communication driver will be set up.
9.
Click [Finish],
40