Panasonic PV C2020 - Manual (Page 20)

TV Timer Features
ON-TIMER with Alarm
This unit can be set to automatically power on in one of 3 modes (TV,
Playback, or FM radio.) You can also combine the On-Timer with a one
minute alarm that gradually increases in volume.
Display PROGRAM
screen.
Press PROGA/CR+.
2
SET PROGRAM
VCR PIUS+ PROGRAMMING
TIMER PROGRAMMING
SELECT
SET
END A » KEY
► KEY
PROG KEY
Select ON-TIMER.
1) Press AW
to select.
2) Press ► to
display.
3 \|/0N n>IMER
6;-AM CH-
ALAmH>or/l;
kl':||j^a!Mil:V
SELECT:A ▼ KEY
SET :► KEY
END :PHOG KEY
ON-TIMER mode selection order
|<^CH02—CH03... CH125-'!
CH01 PLAY
^FM9—FM8' FM1-
Set the ON-TIMER TIME.
1) Press AT to
select.
2) Press ►
to set.
• Make sure a tape is
inserted if Playback
mode is selected.
• See "FM Radio" on
pages 24 and 25 for
instructions on how
to preset FM
stations.
4
ON TIMER
ALARMiON ABC
ELECT ALARM
CANCEL;ADO/DLT
SELECT
: a t KEY
SET :•< ► KEY
END :PROG KEY
KEY
Set Alarm.
Press AT to
select “ON” or
“OFF.”
When “ON” Is selected,
an alarm will gradually increase in volume for one minute or until
canceled by pressing any button (including VOL
+
-.)
To Make Corrections,
use AT and ◄ ► to move back and correct as necessary.
Set ON TIMER.
Press PROGA/CR-f.
• “ON TIMER set ” is displayed.
• ON TIMER indicator lights on the unit.
I^^Check list before you begin.
□ The clock is set to correct time.
To cancel ON-TIMER set.
Repeat steps 1 and 2. Then, press ADD/DLT to clear the time in step 3.
Now, press PROG to end. “ON TIMER END" appears on-screen for a
few seconds.
20
If no button on the remote or unit (including
a button used to turn off the alarm) is
pressed within 60 minutes after unit turns
itself on, it will turn itself back off.
For assistance, call 1-800-211-PANA(7262)