Panasonic CT-30WX50 - Manual (Page 7)

Installation
Remote Control Battery Installation
Requires two AA batteries
1 Turn the Transmitter face down
Remove top cover by pressing
down on marking and sliding cover
off in the direction indicated
Install the batteries as shown in
the battery compartment (Polarity
+ or - must match the markings in
the compartment)
Replace the cover and slide in
reverse until the lock snaps
Helpful Hint:
For frequent remote control users, replace old
batteries with Alkaline batteries for longer life
Note: In order to maximize the life of the batteries, the
lighted buttons on the Remote Control can be turned OFF
and ON by pressing R-TUNE and RECALL at the same
time.
A
Precaution on battery use
Incorrect installation can cause battery leakage and corrosion that will damage the remote control transmitter
Observe the following precautions:
1 Battenes should always be replaced as a pair Always use new batteries when replacing the old set
2 Do not combine a used battery with a new one
3 Do not mix battery types (example “Zinc Carbon” with “Alkaline”)
4 Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries
5 Battery replacement is necessary when remote control acts sporadically or stops operating the TV set
Helpful Hint:
Whenever you remove the battenes, you may
need to reset the remote control infrared
codes We recommend that you record the code
on page 62, prior to setting up the remote