Press tuner band to select band, Press tune mode to select “preset” or “manual, Press v or a to select the desired broadcast – Panasonic SC-AK25 User Manual
Page 12: Adjust the volume level, Auto tuning, If noise is excessive in the fm stereo mode el, Listening to radio broadcasts, F_f ). _f l.ì, Liif
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Listening to radio broadcasts
BAMD
i TUNER
J” /1
>1
O
~i >~i
>11
f_f ). _f L.Ì
t i \
O
i~ i~ r~
r~ n
C lì
I—
»It n h I I t n I
I I ) I ) if U I t
liif
El
Press TUNER BAND to select band.
The power wiil come on automatically.
Every time you press the button;
Press TUNE MODE to select “PRESET” or
“MANUAL”.
Every time you press the button; “MANUAL”«—>“PRESET’.
PRESET: For preset stations
MANUAL: For non-preset stations
Press V or A to select the desired broadcast.
“STEREO” lights when an FM stereo broadcast is being re
ceived. “TUNED” lights when you precisely tune in a broadcast
station.
Adjust the volume level.
Auto tuning
Auto tuning is an easy way to tune in non-preset stations in the
“MANUAL" mode.
Hold down either
v
or
a
,
and release the button when the fre
quency starts scrolling.
The radio will stop automatically on the first station it picks up.
•When there is outside interference, the radio sometimes stops on
a certain frequency where no station is broadcasting.
To stop auto tuning
Press either v or
a
again.
If noise is excessive in the FM stereo mode El
Press FWI MODE/BP. “MONO" will light up,
Sound will be produced in monaural, but this also reduces noise.
Press the button again to cancel. “MONO” will go out.
Normally, you’ll want to listen in stereo, so leave “MONO" off. This
way, you can listen to stereo broadcasts in stereo, and monaural
broadcasts in mono.
You can preset an FM station monaural by following the steps under
“Presetting only your favourite stations” on page 11.
After selecting the station in step 1, select “MONO" with FM MODE/
BP, then continue with step 2 and 3.
•
• If you preset stations in memory, you can tune in a preset station
by simply selecting the preset channel with the numeric buttons on
the remote control.
1. Press TUNER on the remote control.
2. Press the numeric button{s) to select the desired channel.
Press
> 10
and then two numbers you want within 10 second or
so.
• Sound is momentarily interrupted if you load/unload tapes while lis
tening to an AM broadcast.