Panasonic CY-V7100U - Manual (Page 21)

General
Power
Turn your car's ignition key to ACC or ON position.
ON: press [MODE] (POWER) on the display unit.
Press [PWR] (Power) on the remote control.
OFF: press [MODE] (POWER) again for more than
2 seconds on the display unit.
Press [PWR] (Power) again on the remote control.
Mode
I
Press [MODE] to change the mode.
■ ■
i—► ” ” -rPt
Note: If VTR 1 is selected in “Video Control Setting” on
page 22 on the condition that an external device is con­
nected to the VTR 1 terminal of this unit and the video
control leads from both this unit and the device are con­
nected to each other, the VTR 1 mode becomes active
immediately after turning on the power of the external
device.
[VOL V]
[VOL
A]
[MODE]
(POWER)
Audio Output Terminal for Wired Headphones
[PWR] (Power)
[MODE]
Wofliiie (Only for wired headphones)
[VOL A]: up
[VOL V]: down
Default: 20
Setting Range: 0 - 30
VOL 22 iilliililillii»
Note: The volume is not adjustable during Video Control
Setting, IR-OUT Setting, and Display Setting. (*# page
22-25)
Tift Angle
Push the upper part or lower part of the monitor gently
with both hands as shown in the figure.
: Caution: Do rsot apply excespr.-t force lo the iTionvor
• Be careful om ts c.iiseeae your Tngerr, :
if.: xjn ip i: yC::-1:0 v:: h l;':- f cf te c ft:.- tv: :!• y''-/
Note: After adjusting its angle, also adjust the brightness
according to your preference. (# page 24)
J _____[VOL A]
[VOL V]
CY-V7100U
2 1