Panasonic SC-AK27 - Manual (Page 19)

f *
\
f TltCUOOE \
Listening to tapes
Types of tapes which can be played correctly:
The unit automatically identifies the type of tape.
NORMAL POSITIONnYPE 1 O
HIGH POSITIONyTYPE II o
METAL POSITIONATYPE IV 0
You can use either deck 1 or deck 2 for tape playback.
□ Press [TAPE].
The power will come on automatically.
Press [± DECK 1 OPEN] or [± DECK 2 OPEN] and
insert the tape.
Insert the tape with the exposed tape facing down.
Close the holder by hand.
Press [REV MODE] to select the reverse mode.
Every time you press the button:
Z z:>^cz:>
t________ I
^ : One side is played, then playback stops automatically.
¡13 : Both sides (front side reverse side) are played one
time each, then playback stops automatically.
CZ5 : Both sides are played 8 times each, then playback stops
automatically.
Press [^4] or [^] to start playback.
► : The forward side (front side) will play.
< : The reverse side will play.
Adjust the volume level.
To stop tape playback
Press {■!.
To change the deck to be used Q
Press [TAPE DECK1/2] to select the deck you want to use when you
load cassettes into both decks.
To listen to 2 tapes consecutively
Load a tape into each deck and select “CZ5”- Both tapes will be
played 8 times each.
liBBi
Playback is momentarily interrupted while playing back tapes, if you
open the other deck.
To fast-forward or rewind the tape Q
Press or [►►/►►!] In the stop mode.
Tape direction To rewind To fast-forward
T>”
To find the beginning of a program O
(TPS: Tape Program Sensor)
Press or [^>^/^>^] during play.
Tape direction
{To play the current
tune
from the
beginning)
(To play the next
tune from the
beginning)
[►►/►►I]
[►►/►►I]
The TPS function searches for silent parts of about 4 seconds in
length which are normally found between tunes. As a result, it may not
function property in the following cases:
• With short silent parts
• When noise occurs between tunes
• With silent parts found within tunes
Wt
C
.0
*<c
s
I
.s’
c
£
•s