Panasonic SC-AK27 - Manual (Page 30)

Using the timer
QifeObi© (to
I
h,
Q)
I
To switch the timer OFF
Press [0PLAY/0REC] and check [©PLAY/0REC] indicator lights off.
If you set the timer incorrectly
Repeat the procedure from step Q.
To check settings
Press [CLOCK/TIMER] to select “0PLAY" (for play timer) or “0REC”
(for record timer).
Two seconds later, the display will change in the following order:
• For play timer
® Play start time
( 2 ) Play end time
(® Play source and playback volume
• For record timer
® Recording start time
® Recording end time
@ Recording source
You can check the settings even when the system is OFF.
To enjoy the desired source after the timer setting is completed
The volume level (lor play timer) and music source are stored in the
timer memory and the timer will start in these preset conditions.
However, the Disc number and reverse mode do not get stored in the
timer memory.
1. After step B, start playing the desired source.
2. Reset the Disc number and reverse mode if you have changed
any of them, confirm that a Disc or cassette is inserted, then press
[0/1] to put the unit on standby.
Turning the timer ON/OFF
As long as [0PLAY/0REC] indicator lights up, the timer will come ON
everyday as set.
You can turn the timer ON/OFF by pressing [0PLAY/0REC] while the
system is off.
Remember that when [0PLAY/0REC] indicator lights up, the timer is
ON. When lights off, the timer is OFF.
If the power is on, the timer will not function. The system must be
in the standby mode.
If you switch the power to the standby mode while the play/record
timer is functioning, the OFF time setting will not be activated.
If AUX is selected as the source, when the timer comes ON, the
system will turn ON and will engage “AUX” as the source. If you
want to playback or record from a connected component, set the
component’s timer to the same time. (See the instruction manual
that came with the component.)
The play timer cannot be used in combination with the record
timer.