Panasonic CF-VCW722 - Manual (Page 6)

Using the Drive
Installing/Removing a Drive
Refer to the Reference Manual included with your computer on how to install/remove the drive.
..................................
Be sure to turn the computer off before installing/removing the drive.
Preparations
Confirm the following contents in [Start] - [Settings] - [Control Panel] - [System] - [Device
Manager] - [CDROM] - [MATSHITA UJDA***] - [Properties] - [Settings]. Make the set­
tings if they have not yet been made.
• Add a check mark for [DMA],
• Set both [Start drive letter] and [End drive letter] in [Reserved drive letters] to [L:].
If the product number of your computer is CF-72N3*****, be sure to carry out the follow­
ing procedure before starting the instaliaiion of ‘‘Easy CD Creator 4/DirectCD'^^ 3”.
1 Confirm that the drive letter for the CD-R/RW Drive Pack is “Lt”.
2 Confirm the Bay Swap version.
(1) Right-click the BaySwap icon on the taskbar, then select [About].
(2) Confirm that the version shown fdiowing “BaySwap (TM)’' is “ 1.12,8’ then clkik [OK],
3 If the version is “1.1,2.8”, update BaySwap with the following steps.
(1) Select [Stan] - [Settings] - [Control Panel] - [Add/Remove Programs].
(2) Select [Phoenix BaySwap], then select [Add^emove].
(3) At the [Confirm File Deletion] screen, select [Yes],
(4) When the completion screen is displayed, select [OK],
(5) At the confirmation screen, select [OK],
(6) Close the [Add/Remove Programs] screen and restart the computer.
(7) Set the Easy CD Crealori"M 4/DirectCD™ 3 CD-ROM in the CD-R/RW drive.
(8) When the installation screen is displayed, click [XJ.
(9) In [Start) - [Run], input “L:\BaySwap\SETUP.EXE”, then select [OK],
Follow the on-screen instructions.
(10) In [Start] - [Run], input “C:\UTIL\BAYSWAP2\SETUP.EXE”, then select
[OK], Follow the on-screen instructions.
(11) When the setup process completes, remove the CD-ROM and restart ite computer.
Confirm that [Transfer Mode] is set to [DMA if available] in [Start] - [Settings] - [Control Panel] -
[System] - [Hardware] - [Device Manager] - [IDE ATA/ATAPI controllers] - [Secondary IDE
Channel] - [Advanced Settings] - [Device 0]. Perform this setting if it has not yet been made.
Confirm that [Transfer Mode] is set to [DMA if available] in [start] - [Control Panel] -
[Performance and Maintenance] - [System] - [Hardware] - [Device Manager] - [IDE AT A/
ATAPI controllers] - [Secondary IDE Channel] - [Advanced Settings] - [Device 0]. Per-
5 form this setting if it has not yet been made.