Panasonic PV-HS1000 - Manual (Page 44)

I
niversal Remote Control
(continued)
Learning the Codes Programmed Into the Remote
If you set up the Hard Disk Recorder remote by following “Searching for Your
Component's Code" on page 43, you may want to figure out which four-digit
code is operating your equipment. Use this procedure after you set up your
components to find out which four-digit code is operating your equipment.
For example, to find out which code is operating your TV after setting up
your TV, follow steps below.
1
Press TV.
buttons (TV, SAT/CABLE, or VCR/DVD) to control other home
entertainment components.
For example, to control a TV, a cable box, and a DVD player, you will need to
re-assign the VCR button to operate the DVD player, follow the steps below.
3. f
Hold down CODE SET until the remote’s red ^
LED blinks twice, then release.
Reassigning device keys
b[
Press 9 - 9 - 2 . The red LED will blink twice.
c
Press VCR/DVD twice. The red LED will blink twice,
You can now program the VCR/DVD button for your DVD player.
dG
See “Setting Up Your Components’’ on page 42.
To reassign other component mode buttons...
Repeat steps aMj by substituting the button sequence from
the list of popular components at right.
44
TV as 2nd
VCR button
Press: CODE SET
9-9-2-VCR-TV
TV as 2nd
CABLE button
Press: CODE SET
9-9-2-CA8LE-TV
TV back to TV Press: CODE SET
9-9-2-TV-TV
VCR as 2nd
TV button
Press: CODE SET
9-9-2-TV-VCR
VCR as 2nd
CABLE button
Press: CODE SET
9-9-2-CABLE-VCR
VCR back to VCR Press: CODE SET
9-9-2-VCR-VCR