Panasonic RX-DT39 - Manual (Page 15)

Before
(Recording cannot be made.)
To take up the leader tape: 0
Only normal tapes can be used.
The sound may not be recorded properly if high position tapes and
metal position tapes are used with this unit.
Any changes made to the volume or sound quality during recording
will not affect the recording.
In order to prevent trouble caused by flat batteries, it is
recommended that you either supply power to the unit from the
household AC outlet or replace ail the batteries with new ones
when you are recording something which is important to you.
The recording level is set automatically.
If the unit is brought near a TV set during recording, noise may be
recorded due to the effects of the signals from the TV set. Maintain a
distance of at ¡east 1.5 metres between the unit and a TV set,
To make a blank tape:
1. Load the recorded tape with the side to be erased facing upward.
2. Set [SELECTOR] to TAPE/OSI".
3. Press [® 13^ ].
PLAY] is also depressed with [@ giTi^].
Your attention is drawn to the fact that recording pre-recorded
tapes or discs or other published or broadcast material may in­
fringe copyright laws.
from radm broadcasts
/Onlx ^ ^
STOPiEJECT
Press deck 1 STOP/EJECT] and load the tape.
Load the tape with the side to be recorded facing upward.
Tune in the broadcast station.
(See pages 8 and 9.)
Press [© to start recording.
PLAY] is also depressed with [® |3^].
To stop the recording:
Press [S/^ STOP/EJECT],
To stop the recording temporarily:
Press [El PAUSE].
To resume recording, press (11 PAUSE] again.
To reduce noise while recording an AM broadcast
(Beat proof function) @
by remote control only
Press [FM MODE/BP] when recording or in the recording standby
mode.
Each time you press the button, “bPT' and “bP2" will be displayed
alternately. Select the position with the least noise.