Sehing the subwoofer processor, Protection circuits for ws-at300, System diagram – Panasonic RAMSA WS-AT350 User Manual
Page 8: Audio, Mixer, Setting the subwoofer processor
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SEHING THE SUBWOOFER PROCESSOR
For further details please refer to the Operating Instructions of the RAMSA Subwoofer Processor WS-SP2A.
RECOMMENDED FUNCTION SELECTOR SETTING
SUB WOOFER
MAIN SPEAKER
FUNCTION SELECTOR POSITION
1 2 3
1 2 3
WS-AT350
WS-AT300
0
t £. vJ
1—^
Ì £ •u
S I S s L d
VLFI
A K
1 2 3
b_Ld
cc
cc
1
m
PROTECTION CIRCUITS FOR WS-AT300
• The WS-AT300 has separate overload protection
circuits for woofer and tweeter. 'When activated by an
excessive input signal, they mute the output sound.
Turn down the volume control for 2 to 20 seconds to
reset the circuits.
Note: Make sure to lower the volume control of the
amplifiers if the output sound suddenly decreases.
Keeping or even increasing the volume can cause
serious damage to the speaker.
SYSTEM DIAGRAM
This shows an example of system connections.
Audio
Mixer
In A
In B
WS-AT300
WS-AT350
-
8
-