Recall button, R-tune button, For ct-27g22/u and ct-27s21) – Panasonic CT-27G22 User Manual
Page 16: Recall button r-tune button, Special functions, Helpful hints, Multi button
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Recall Button
Press the RECALL button to review:
(J) Audio Mode status
@ CH number or Video Input selected
@ Channel Caption (Station Identifier)
(
4
) Clock time
Sleep Timer status
Special Functions
R-Tune Button
Pressing the R-TUNE (RAPID TUNE) button will switch
between the last two channels selected on the numeric
keypad.
Note: When rapidly scanning channels with the
CHANNEL UP/DOWN button, pressing the
R-TUNE button will switch between the last
channel scanned, and initial channel at the start
of scanning.
CHANNEL
NOW
BEING VIEWED
Press Button
Press Button Again
4
CHANNELTUNED
IMMEDIATELY BEFORE
Helpful Hints:
Press the TV Mode Selection button to operate TV
Remote functions, if necessary (some models).
(For CT-27G22/U and CT-27S21)
The MULTI button can be programmed to operate up
to six (
6
) Remote function buttons at the same time.
For Example: TV Power/On, VCR Power/On, and
Cable box Power/On (selected brands) can be operated
at the same time with one press of the MULTI button.
(The VCR Mode button should be programmed
before starting procedure).
Procedure
1. Program the Remote for the selected device Infrared
access code. Confirm that the Remote Control is
compatible with the device.
2.
Face the Remote Control transmitter away from all
equipment remote sensors.
3.
Press and hold the Remote POWER button, then
press and hold the ACTION button down at the
same time for three seconds. (All previous
commands are erased.)
Multi Button
PRESS AT THE SAME TIME FOH
THREE SECONDS
4.
release
POWER and
5.
6
.
After three seconds,
ACTION buttons.
Press the MULTI button. (Waiting more than 30
seconds without pressing another button will exit the
programming mode.)
Press a maximum of six (6) function buttons on the
Remote Control.
Each button you press is equal to one function. If six
(6) Remote button functions are entered, all will
register in the MULTI button memory in the
sequence entered. When finished, press the MULTI
button to exit the programming mode.
The following is an example flow chart of Remote
functions that can be programmed into the MULTI
button.
You can now turn the TV and VCR ON/OFF at the
same time with one press of the MULTI button.
To delete entered functions - Press and hold the
Remote POWER button, then press and hold the
ACTION button down at the same time for three
seconds. You can now enterfrom one to six different
Remote functions.
Note; You can also program the MULTI button to
perform most individual Remote Control button
functions. Buttons which continuously perform a
function as long as pressed (Volume Up/Down,
Channel Up/Down, etc.) cannot be programmed:
only those buttons which perform a function
when initially pressed (Power On/Off, Mute,
Direct Channel Entry, etc.) can be programmed.
-
16
-