Programming the home theater remote (forct-27s2i), Code known, Code unknown – Panasonic CT-27G22 User Manual
Page 29: Infrared remote codes for specific components
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Programming the Home Theater Remote (ForCT-27S2i)
The remote control can be set to control other manufacturers components, by utilizing the MODE SELECTION
BUTTONS for CABLE, DSS, VCR, RCVR (a Receiver or Amplifier), CD, LD, and AUX (for Cassette Players, Second
VCR or a DVD.)
Code Known
Use the following procedure for setting up the
remote control using the numerical buttons
when the component’s remote code is known.
m Determine the brand of the component.
F2l Identify the code(s) .associated with the
brand from the infrared code index {see
following pages). Record all possible
codes.
m
Code From
Index Sheet
Confirm that the component is plugged
in and operating properly, then turn it
OFF.
in Press and hold the(^) button, then
the
button so that both are
pressed at the same time for at:least]
f5_secpnds. All Mode buttons will
flash, then let go of the buttons.
Press the appropriate Mode button
for the component. The pressed
button will illuminate steadily. All
other buttons will go out.
Enter the 3-digit code, by using the
Remote
Control
Keypad
“0”
through ”9” buttons. If a proper
code was entered, the Mode button
will blink twice then go out.
Now the remote is set for the
entered code.
F
t
] Press the button to test the remote. If
the
correct
code
is
setup
for
the
component (in step [SI), the component
will turn on.
NOTE:
Some brands have multiple codes.
Repeat the procedure using another
listed
code
until
the
component
responds correctly.
EUR511060
Code Unknown
Use the following procedure for setting up the
remote control when the component’s remote
access code is not known. This procedure
uses the ’’sequence method”.
Confirm that the component is plugged
in and operating properly, then turn it
OFF.
Press and hold the
button,
then the button so that both
are pressed at the same time for
at
All Mode buttons
will flash. Then let go of the buttons.
m
Press the appropriate Mode button
for the device. The pressed button
will illuminate steadily. All other
buttons will go out.
Press the button to step
over to the next code.
Press the button to test the
remote. If the correct code is
sent, the component will turn on.
Once the correct code is found,
press the
button
to store the code.
Repeat from step above until the
proper component code is found, it
may take several attempts before
the correct code is found.
NOTE:
If an incorrect code is entered, or
when
the
operation
is
not
completed within 30 seconds, the
settings will not change.
Infrared Remote Codes for Specific Components
Helpful Hint:
Write down the code numbers for your components in the space provided below. This
will serve as a handy reference whenever you need to reprogram your remote control.
CABLE
Cable TV Converter Box
n □
VCR
Videocassette Recorder
□□
CD
Compact Disc Player
I
DSS
Digital Satellite System
RCVR
Receiver or Amplifier
□
LD
Laser Disc Player
* <*
I
□
Other Component
other Component
Other Component
n
I
Other Component
II Other Component
II Other Component |
-
29
-