Remote control basics, Continued, Main unit – Panasonic CQR255SEUC User Manual
Page 20: Power, Volume, 0 /\voln/ (volume control button), Mute, Radio, To change radio mode 0 mode (mode button), Manual tuning
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Remote Control Basics
continued
Operating Procedures
I Aim the remote controller toward the sensor of the
main unit.
General
Power
O
PWR (Power Button)
• Press PWR to switch on the power.
• Press PWR again to switch off the power.
Volume
0 /\VOLN/ (Volume Control Button)
Press or “N/” to increase or decrease vol
ume level.
Mode Selection
0 MODE (Mode Button)
Press MODE to switch the operation mode as
follows.
Radio 4 TAPE 4 CD Changer Control
t________________ *
Mute
O MUTE (MUTE Button)
• Press MUTE. MUTE is activated.
• Press MUTE again to deactivate when listening
at normal volume.
Radio
To Change Radio Mode
0 MODE (Mode Button)
Press MODE to select Radio Mode.
Radio
4
TAPE
4
CD Changer Control
t________________ *
Manual Tuning
© '♦^TUNE^*'(Manual Tuning,Button)
Press “-«TUNE" or “TUNE^*-" to move to a
lower or higher frequency.
Selecting a Band
0 BAND (BAND Button)
Press BAND to select the band in sequence.
Seek Tuning
0 '♦^TUNE^^ (Seek Tuning Button)
Press and hold “-♦^TUNE" or “TUNE^^” for
more than 0.5 seconds, then release. The radio
automatically stops on the next station.
20
CQ-R255SEUC