Electrical connection – Panasonic CQR255SEUC User Manual
Page 29
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Electrical Connection
• This unit can be connected to an optionai CD changer {CX-DP801EUC). For details consult your nearest
Panasonic dealers.
• For connection to a CD changer, refer to the operating instructions of the CD Changer (CX-DP801EUC).
Caution:
• To prevent damage to the unit, be sure to follow the connection diagram below,
• Remove the covering of the leads about 5 mm long from their end before connecting.
• Do not insert the power connector into the unit until the wiring is completed.
• Be sure to insulate any exposed wires from a possible short-circuit from the car chassis. Bundle all cables and
keep cable terminals free from touching any metal parts.
CX-DP801 EUC
Fuse(3A) „
„
•
Battery Cord
To a Constant power supply
Gropund lead
(To a clean,bare metallic
part of your car)
Be sure to connect to a well grounded
metallik part of your car because noises or
troubles may occur.
DIN Extension Cord
hi
BATTERY LEAD
(Connect to car battery]
POWER
(+12V DC.negative
ground only)
GROUND
(Connect to a clean,
bare metallic part of
your car.)
MOTOR ANTENNA
RELAY CONTROL
(moves antenna up
and down)
AMP RELAY CONTROL <
POWER LEAD
(This lead Is for connec
tion to Panasonic power
amplifier)
LEFT SPEAKER RIGHT SPEAKER
(FRONT )
(FRONT )
LEFT SPEAKER RIGHT SPEAKER
(REAR)
(REAR)
CQ-R255SEUC
29