Panasonic RX-FT500 - Manual (Page 7)

$^NCHR0ri|Z№E^^
When the Tape 2 Pause and Record Buttons are pressed,
tape editing starts by pressing the Tape 1 Playback Button.
1. Insert the playback tape into Tape 1 and the editing tape
into Tape 2.
2. Set the Function Selector to “TAPE/POWER ( off T*.
3. Set the Editing Mode Selector to the desired position.
“NORMAL" ................. normal speed
"HIGH" ........................ high speed
4. Press the Tape 2 Pause Button, then press the Record
Button.
5. Press the Tape 1 Playback Button.
•Editing is started by means of the Synchro-Start
function.
6. To stop editing, press the Stop/Eject Button (Tape 1 and
Tape 2).
Notes:
•Do not change the Editing Mode Selector during
editing. The playback sound may flutter.
•Be sure to set the Function Selector to “TAPE/
POWER jOFFi” during editing. Do not change the
selector to any other position.
•Some TV sets generate noise that could be
recorded during editing.
To prevent the possibility of this do not use this unit
closer than 1.5 m to a TV set.
RECORD PREVENTION TABS
Cassettes are provided with plastic tabs (as illustrated) to
prevent accidental erasing of a recording.
Recordings can be made only when the tab is intact. There
is one tab for each side (track) of the tape. To preserve a
valuable recording, the tab(s) should be broken off with a
small screwdriver.
If you want to record on a track whose tab has already been
broken off, use cellophane tape to cover the hole, and
record.
Screwdriver
a
NO
•[RECORD
f
OK
• [RECORD
Tab Cellophane tape
-7 -