Listeningia radio broadcasts, Press tuner, band to select, Fm”, “mw” or “lw – Panasonic SC-CH75 User Manual
Page 11: Press tuning mode to select “preset, Press v or a to select the preset channel, Turn volume>to adjust the volume as you like, For your reference, Izbsi, Listening to radio broadcasts, Preset tuning
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Listeningia radio broadcasts
Preset tuning
Be sure you’ve completed the steps in “Memory presetting” on page
10
.
I This example in the figure shows how to listen to FM preset channel
' 3.
BAND
Press TUNER, BAND to select
( nJHEIKi
I I
"FM”, “MW” or “LW*
I For Australia and New Zealand {
Note that for Australia and New
Zealand, there are two bands of "FM”,
"AM” instead of “FM”, “MW”, "LW”.
The power will come on automatically,
even if the system is on standby.
Press TUNING MODE to select
“PRESET”.
Each time you .press the button,
“MANUAL” and "PRESET" will appear al
ternately.
Press V or A to select the pre
set channel.
"STEREO” lights when an FM stereo
broadcast is being received. “QUARTZ
LOCK" lights when you precisely tune in
a broadcast station.
Preset channel
FM
8
8
.
О
Turn VOLUME>to adjust the
volume as you like.
/'TTn t
•I'S
о
Manual tuning
If the frequency is not known, use the tuning buttons for searching.
3.
Press TUNER, BAND to select band,
Press TUNING MODE to select "MANUAL”.
Each time you press the button, “MANUAL” and “PRESET' will
appear alternately.
Press V or A to tune in the desired broadcast.
Repeatedly tapping on the button will change the frequency one
step with every touch. Holding it down will scroll the frequency.
While scrolling, if the radio picks up a station, it will automatically
tune it in (auto tuning).
4. Turn VOLUME to adjust the volume as you like.
Tuning may stop automatically if any jamming is encountered.
Switching the mode from stereo to monaurai
while iistening to an FM station:
Press FM MODeBP.
The sound reception mode switches to “MONO” (monaural)
and “MONO” lights.
When “MONO” indicator lights up:
Use this setting when listening to or recording in monaural. All
sound reception including stereo sound, is in monaural.
When “MONO” indicator goes off:
Use this setting for normal listening. Both stereo and monau
ral sounds can be heard as they are.
For your reference:
If too much noise is produced in the FM stereo mode, press
FM MODE/BP and check “MONO" lights up.
The sound will then be heard in monaural. If the broadcast
signal is weak, or if there is a large amount of interference, you
will get a clearer sound in “MONO" mode.
IZBSi
You cannot memorize the stations in the "MONO" mode.
11