Panasonic SC-CH75 - Manual (Page 25)

The recording level and the Dolby effect will be recorded as they are
on the tape being played back.
Advance the leader tape a few revolutions.
DECK1/Z Press TAPE, DECK 1/2.
DECK 1 DECK 2
Press A OPEN on both decks,
and then insert the tapes.
For playback: Into deck 1
For recording: into deck 2
Close each deck's holder.
:y.
Press REV MODE to select the
reverse mode.
Single-sided recording
Two-side recording
(forward side~>reverse side)
Same as above (When you press
NORMAL or HIGH, “c:^^ will be
automatically switched over to
T H P S
O
Press or immediately fol­
lowed by ■.
This selects which direction the tape runs
tn.
► ; Recording from forward side
◄ : Recording onto reverse side
Set both deck 1 and 2 to run in the same
direction, side A.
To switch over between decks 1 and 2
Press TAPE, DECK 1/2.
To record onto side B, set deck 2 to run in
the ◄ direction.
TAPE EDIT
I I I
Press NORMAL or HIGH of
TAPE EDIT to start recording.
NORMAL: Normal speed recording
HIGH:
High speed (about 2 times
norma! speed) recording.
Recording starts at the selected speed.
Tape travel direction indicator
The tape travel direction indicator shows
the tape travel direction of the tape for
recording.
After recording has finished, both decks
will stop.
To stop recording
Press ■.
Both decks will stop.
•While making a high-speed recording, move visual units such as TV
further away from this unit. It prevents noises from being recorded.
• You cannot record acoustical effects such as bass or changes in
sound quality and field.
25