Problem solving, Repalcing the fluorescent lamp, Replacing the fluorescent lamp – Panasonic UF-250 User Manual
Page 73
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
PROBLEM SOLVING
REPALCING THE FLUORESCENT LAMP
If the receiving party reports that the received documents were black, or
contained black bands, try making a copy on your unit. If the copy is black or
has black bands, the fluorescent lamp is probably defective and must be
replaced.
NOT€
H
The fluorescent lamp is very hot when the unit Is turned on. Wait 5 minutes or
more after turning the power switch OFF, before replacing the lamp.
1. Turn the power OFF (O).
Remove the ADF tray and stand the unit up, then remove the Bottom Board
Unit screws. •
Wheri inserting a new fluorescent lamp, make sure that the transparent
part faces you and the manufacturer’s mark is at the lefthand corner.
Replace the screws and return the unit to its original position.
Turn the power ON (I).