Panasonic KX-F220 - Manual (Page 112)

TROUBLESHOOTING GUIDE
(CONT.)
FACSIMILE
PROBLEM CAUSE & REMEDY
I cannot receive documents automatically.
Recording image is scratchy and cannot be
read completely.
The other party complains that documents are
being received with distorted letters.
The START/COPY indicator flashes for about
40 seconds after the unit receives a call
automatically, but nothing is recorded.
•Make sure that a recording paper is installed.
•Make sure the unit is set to the Auto Receiving mode.
•Shorten your OGM and ask the other party to press
(ASTERISK) to transmit a document.
The sender transmitted a light density document. Have the
other sender darken the document (e.g. by copying) then have
them transmit it again.
• If you have call waiting service, it may have been activated by
another telephone call. Re-connect the unit to a line that does
not have call waiting service.
•Someone may have used a telephone connected in parallel
with the unit. Avoid connecting the same line for the unit and
other telephones.
The caller hung up during or immediately after the playback of
the OGM. This may occur if the disconnect signal is not
transmitted from the Central Office, and your unit is in normal
condition.
When I receive or copy a document whose
background is very dark or containing
photographs, the unit may produce a high tone.
This is quiet normal.
I cannot send a document to my KX-F220 even The remote Fax ID may be turned on.
after I press Enter your remote Fax ID after pressing
The unit does not operate properly.
Problems of receiving international
facsimiles.
Turn the POWER switch off, then turn it on again.
• Refer to page 4-14.
•Shorten OGM to 10 seconds or less.
•G HI receiving speed may need to be set to 4800 bps.
•CED frequency may need to be set to 1100 Hz.
4-3