Panasonic TX-86W100A - Manual (Page 29)

Manual Tune
This Television has been factory tuned to all the major city channels. Use this tuning procedure only if you wish
to reset individual Programme Numbers,
The television should be switched ON and the TV/AV Switch set to TV.
Using the Front Panel Using the Remote Control
1
.
2 .
3.
4.
5.
6
.
7.
8 .
9.
10
.
11 .
12
.
Push the
F
button repeatedly until the Tuning
Menu is reached.
Push the - / V or + / A button to access the
Tuning Menu, (See page 27).
Push the
F
button to access the Manual
Tune.
Push the • / V or + / A buttons to select the
Manual Tune.
MANUAL TUNE (FRONT FWNEL)
: SEARCH
TV/AV : MOVECURSOR
STR : TO STORE
: TO EXIT
:V 'Ü "
0
- ■
F
:p O
m
TJ
TVWV
Push the F button to switch to "Change
Programme".
Use the - / V or + / A buttons to select the
programme location number to tune.
Push the F button to switch to "Search".
Push the - / V or + / A Button to start the
search.
The television will automatically search for
the next broadcast signal. As each station is
found the search will stop. If you do not want
this station restart the search.
Push the STR to store the selected station.
Push the F button to return the television to
the Tuning Menu.
To return the television to normal operation
push the F button repeatedly until the volume
display appears.
TV№V
1 .
2 .
3.
4.
5.
6 .
7.
8 .
9.
10 .
Push the Set Up@ button.
Push the A or V button to select the Tuning
Menu. (See page 27).
Push the - or + button to access the Tuning
Menu.
Push the A or V button to select the Manual
Tune.
Push the - or + button to access the Manual
Tune.
Push the A or V button to select the
programme location number to tune.
Push the - or + button to start the search.
The television will automatically search for
the next broadcast signal. As each station is
found the search will stop. If you do not want
this station restart the search.
Push the STR to store the selected station.
Push the Set Up button to return the
television to the Tuning menu.
Push the HP button on the remote control to return the television to normal operation.
Tuning the Television to a VCR
1. Turn the VCR On and either start a known tape playing or set the VCR Test Signal, if fitted, to On
(refer to the VCR operating instructions).
2. Repeat steps 2,3 and 4 of the Manual Tuning procedure above. The television will treat the VCR as if
it was a normal television broadcast station.
NOTES:
1. The antenna lead must be connected to the VCR and the VCR RF-Out must be connected to the TV
RF-ln. Please refer to page 39.
2. The picture and sound quality are usually much better if the VCR Is connected using the AV
Terminals. Please refer to page 40.
29