Changing the dust bag – Panasonic QUICKDRAW MC-V5117 User Manual
Page 12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CHANGING THE DUST BAG
Always operate the vacuum with a genuine Panasonic Type U3 or U6 dust bag Installed.
Panasonic dust bags may be ordered through any authorized Panasonic dealer.
1. Pull outward on the
dust cover grip,
located on the top
front of the dust
cover and remove
the cover.
2.
To remove the dust
bag, grasp the
cardboard portion
of dust bag and
pull it out.
3. Spread out the end of the
new dust bag.
NOTE: Pull carefully so
as not to tear the bag at
the folds.
4.
Attach the new dust bag
onto the bag holder by
holding the bag collar
and pushing back as
illustrated.
5. The dust bag must be completely
installed Inside the dust
compartment for proper
operation.
The dust bag should not be
caught between
the lower
edge of the
dust cover and
the gasket as
indicated by the
arrow in the illustration.
6. Reinsert the tab provided on the end of
dust cover into the groove on the dust
compartment and press the cover into place.
NOTE: The dust
cover must be
completely and
correctly
Installed for
proper
operation.
- 1 2 -