Panasonic SC-CH7 - Manual (Page 34)

Listening to Other Sources
DAT PHONO
Carry out the step 1 of “Standard Operations" on page 20.
1 Press the Input selector button marked
Carry out the step 1 of “Standard Operations" on page 20,
U
Press the Input selector button marked
‘DAT”. “PHONO”.
2 operate the DAT.
See the instruction manual of the DAT.
Operate the turn table system.
See the instruction mwiuai of the turn table system.
■ To record on a DAT tape.
After selecting the desired source, follow the 8 ^x>ve procedures,
then start recording.
For details, refer to the DAT instruction manual.
•To prevent a low-pitched noise (“hum”), install a turntable at the
right side of the system, or separate from the system.
Microphone mixing
7 Turn down the volume.
2 Connect a microphone.
3 Play the desired source and adjust the
volume level.
If a strange noise (squealing or howling noise) Is emitted during
mixing, either change the direction of the microphone or turn down
the volume.
To perform mlxlng*recordlng
Put the amplifier in the mic mixing mode, then perform the
operation of “Recording". (See page 40.)
Note:
Mixing-recording from deck 1 to deck 2 cannot be performed.
-34-