Softride 26496 Hang5 bike rack (New) - Manual (Page 15)

15
Always secure the Hangers to the Rear
Wheel Support Bar with 2 or more
Rubber Straps when driving with the
rack in Stowage Position. Failure to do
so may void the warranty of the rack
and could result in damage to the rack.
For more tips and to see a video of how to use this rack scan this code
with a mobile device or visit: www.softride.com/h5how2
To place the rack into stowage position
remove the two Pivot Pins (2K), fold the
rack down and secure top half of the rack
to the lower half with two or more rubber
straps. The Pivot Pins (2K) can be
reinserted to avoid misplacing them.
The Hang5 assembly can be folded down
into stowage position and for easier
installation and storage.
HANG5 USE INSTRUCTIONS (continued)
HANG5 RACK INSTRUCTIONS
When folding the rack into stowage
position take care not to place hands
between the two support bars where
fingers could get pinched.
(2K)
After returning the rack to use
position from stowage check the pivot
assembly bolts to ensure they are
tightened to each bolt’s torque
specification.
When removing the bike rack from the vehicle always remove the Hang5 Assembly
separately before attempting to remove the Access Base Rack from the receiver hitch.
This rack should only be used with a 2” receiver hitch. Do not use any aftermarket extension,
coupler, or reducer to modify the connection between the rack and the receiver hitch.
pivot bolt