Softride 26496 Hang5 bike rack (New) - Manual (Page 8)

HANG5 RACK INSTRUCTIONS
16
;OLWSHZ[PJ(U[Pɫ-YPJ[PVU7SH[LZ3LM[HUK9PNO[
(2D) and (2E) should arrive attached to the
corresponding inner edges of the Outer Pivot
Plates (2B) and (2C).
17
Position the Outer Pivot Plate w/ Vertical
Hanger Support (2B) along side of the Inner
Pivot Plate (2A) as shown and insert through
the lower 10mm bolt (F) w/ 1 washer.
18
Match the Outer Pivot Plates (2B) & (2C),
2 Hole Metal Spacer (2L), and Plastic
(U[Pɫ-YPJ[PVU7SH[LZ+
,[V[OLV[OLY
side so that all of the holes align as shown.
Tip: Wait until later to completely tighten
the 10mm bolts to make sure all holes will
line up.
16
18 17
ASSEMBLY OF HANG5 RACK (continued)
(2A) Inner Pivot Plate
(2B) Outer Pivot Plate w/ Vertical Hanger Support
(2C) Outer Pivot Plate w/out Vertical Hanger
(2D) & (2E) Plastic Anti Friction Plates
(pre-assembled)
(2K) Pivot Pin
(2L) 2 Hole Metal Spacer
(F) First Bolt Installed
(H) Second Bolt Installed
(I) Third Bold Installed
(2E)
(2C)
(2L)
(2K)
(2B)
(H)
(I)
(F)
(2A)
(2D)
1st
2nd
3rd
8