STIEBEL ELTRON SOM 6 SI - Manual (Page 6)

SOM 6 SI
© 06184 som_6_si.monen.ind
d
| 6
1
3
2
backwards forward
SET
(selection / adjustment mode)
The system display consists of an indication channel, a tool
bar, and the system screen. These are detailed below.
2.2.1 Indication Channel
Indication channel
2.2.2 Tool bar
The additional symbols of the tool bar indicate the current
system status.
2. Operation and function
2.1 Pushbuttons for adjustment
The controller is operated by the 3 keys below the display.
To enter the configuration mode toggle through the display
parameters by pressing and releasing key 1 until this no
longer causes the display to change. At this point press and
hold key 1 until the configuration parameters are displayed
(about 5 seconds), then quickly release the key to avoid tog-
gling to the end of the parameter list. The first parameter in
the list is DT O. To change the setting of a given parameter,
follow the steps below.
1. Toggle to the parameter using keys 1 and/or 2. The
abbreviation for the parameter is displayed on the right
side of the screen, with the setting directly below, and the
set icon solid (not blinking) on the extreme right.
2. Press key 3. The set icon begins blinking signifying that
the parameter may now be adjusted.
3. Quickly use keys 1 and/or 2 to change the setting to
that which is required.
4. Press key 3 again. The set icon stops blinking signifying
that the new value has been stored.
2.2 System monitoring display
Symbol standard flashing
relay 1 active
maximum storage
temperature reached
or exceeded
collector cooling function or
reccoling function active
antifreeze- function activated
collector minimum limitation
or antifreeze function active
collector security shutdown or
store securtiy shutdown active
+
sensor defect
+
manual operation active
The indication channel consists of two lines. The upper
line is an alphanumeric 16-segment display, in which an
abbreviation of the current setting or reading is shown. In
the lower 7-segment display, the value of said reading or
setting is shown.
!



Monitoring-Display
Toolbar only illustrated above