STIEBEL ELTRON SOM 6 SI - Manual (Page 8)

SOM 6 SI
© 06184 som_6_si.monen.ind
d
| 8
3. Controller parameter and indication channels
3.1 Channel-overview
Legend:
x*
Corresponding channel is available if the appropriate option
is activated.

Corresponding channel is only available if the option energy
production measurement is activated (OHQM).
MEDT
The channel antifreeze content (MED%) is only shown if a
medium other than water or propylene glycol is used.
The adjustment is only appropriate when using other types
of antifreeze.

Corresponding channel is only available if the option energy
production measurement is deactivated (OHQM).
Please note:
S3 and S4 are only indicated if sensors are connected.
channel specification page
COL x Collector Temperature 9
TST x Lower Storage Tank Temperature 9
S3 x Sensor 3 Temperature 9
TRF  Return Sensor Temperature 9
S4  Sensor 4 Temperature 9
h P x Operating Hours Counter 9
kWh  Energy Production kWh 10
MWh  Energy Production MWh 10
DT O x Switch-On Temperature Differential 10
DT F x Switch-Off Temperature Differential 10
S MX x Maximum Storage Tank Temperature 11
EM x Collector Emergency Shutdown
Temperature 11
channel specification page
OCN x Collector Minimum Temperature
Limitation 11
CMN x* Collector Minimum Temperature 11
OCF x Antifreeze Function 11
CFR x* Antifreeze Temperature 11
OREC x Recooling Option 12
O TC x Tube Collector Function 12
OHQM x Energy Production Measurement 10
FMAX  Maximum Flow Rate (LPM) 10
FMXG  Maximum Flow Rate (GPM) This is only
available on later release levels
10
MEDT  Antifreeze Type 10
MED% MEDT Antifreeze Concentration 10
HAND x Circulator Pump Operating Mode 12
LANG x Language 12
UNIT x Temperature Units °FAH / °CEL 12
PROG XX.XX Program Number
VERS X.XX Version Number