STIEBEL ELTRON SunWarmth CIR 400-2 O - Manual (Page 13)

WWW.STIEBEL-ELTRON-USA.COM SUNWARMTH ™ CIR INFRARED HEATER| 13
EN
G
L
IS
H
INSTALLATION
INSTALLATION
5. Disconnect electrical supply cord spade connectors from
terminals:
6. Disconnect ground wire (electrical supply cord) from the heater
body by removing the anchor screw from the eye of the ground
terminal:
7. Slide power cord retainer plate from heater body:
2. Remove end cover at both ends of heater. Six (6) Phillips screws
hold the end cover in place. Remove the screws to secure storage:
3. Slide out the face plate at each end of heater to expose both
ends of the heat lamp:
4. Turn heater face down, and slide the center cover plate and
the heater mounting bracket out of the heater: