Operation – STIEBEL ELTRON SunWarmth CIR 400-2 O User Manual

Page 2

Advertising
background image

2

|SUNWARMTH

CIR INFRARED HEATER

WWW.STIEBEL-ELTRON-USA.COM

CONTENTS | OPERATION

IMPORTANT INSTRUCTIONS

1. IMPORTANT INSTRUCTIONS
SAVE THESE INSTRUCTIONS

When using electrical appliances, basic precautions should always

be followed to reduce the risk of fire, electric shock, injury to

persons or death, and property damage including the following:
1. This heater must be installed only by a qualified electrician.

Read and understand all instructions before installing, using or

servicing this heater. Improper installation, operation, adjustment,

alteration, service or maintenance can result in the risk of fire and

electrical shock, and may cause property damage, injury or death.
2. This heater is hot when in use. To avoid burns, do not let bare

skin touch hot surfaces. Keep electrical cords and combustible

materials, such as furniture, pillows, bedding, papers, clothes,

etc. and curtains at least 3 feet (1 m) from the front of the heater

and keep them at least 3 feet (1 m) away from the sides and rear.
3. Extreme caution is necessary when any heater is used by or

near children or invalids.
4. Never leave the heater unattended during operation. Unplug

120 V models or turn off circuit breaker(s) on 240 V models if not

in use.
5. Do not operate any heater with a damaged cord or plug, or after

the heater malfunctions, or if it has been dropped or damaged

in any manner. Return heater to an authorized service facility for

examination, electrical or mechanical adjustment, or repair.
6. These heaters are not for use in bathrooms, laundry areas, and

similar indoor locations. Never locate heater where it may fall into

a bathtub or other water container.
7.

MODEL “CIR 150-1 I” IS FOR INDOOR USE ONLY. Do not use

this model outdoors or in wet environments. Models CIR 150-1

O, CIR 200-2 O, and CIR 400-2 O may be used outdoors or in wet

environments.
8. Do not run cord under carpeting. Do not cover cord with throw

rugs, runners, or the like. Arrange cord away from traffic areas

where it will not be tripped over.
9. Arrange the cord at the side and back of the heater - do not

allow cord to drape over the heater.
10. To disconnect heater remove plug from outlet (120 V models)

or switch off at power source (240 V models).
11. 120 V models CIR 150-1 I and CIR 150-1 O must be connected

to a 120 V outlet that is properly grounded and controlled by a

timer switch.
12. 240 V models must be hard wired to a circuit that is properly

grounded and controlled by a timer switch. Copper wire is

required.
13. Do not insert or allow foreign objects to enter the heater or any

ventilation or exhaust opening as this may cause an electric shock,

fire, or damage the heater. Death, personal injury or property

damage could result.
14. To prevent a possible fire, do not block air intakes or exhaust

in any manner. Do not use on a soft surface, like a bed, where

openings may become blocked.
15. Use this heater only as described in this manual. Any other

use not recommended by the manufacturer may cause fire, electric

shock, and death or injury to persons and property damage.
16. With 120 V models, avoid the use of an extension cord

because the extension cord may overheat and cause a risk of fire.

IMPORTANT: However, if you have to use an extension cord, the

cord shall be No. 14 AWG minimum size and rated for not less

than 1875 watts.

OPERATION

1. Important instructions �����������������������������������������2
1.1 Document information �������������������������������������������� 3
1.2 Key to symbols ������������������������������������������������������ 3
2. Safety ������������������������������������������������������������4
2.1 Intended use ��������������������������������������������������������� 4
2.2 Safety information ������������������������������������������������� 4
2.3 ETL / UL / CSA designation ��������������������������������������� 4
3. Register your product ������������������������������������������5
4. Appliance description ������������������������������������������5
5. Operation �������������������������������������������������������5
5.1 Starting the heater ������������������������������������������������� 5
5.2 Shutting down the heater����������������������������������������� 5
6. Cleaning, care and maintenance ������������������������������5
6.1 Maintenance ��������������������������������������������������������� 5
6.2 Cleaning �������������������������������������������������������������� 5

INSTALLATION

7. Safety ������������������������������������������������������������6
7.1 General safety instructions ��������������������������������������� 6
7.2 Instructions, standards and regulations ����������������������� 6
8. Appliance description ������������������������������������������6
8.1 Standard delivery ��������������������������������������������������� 6
9. Installation ������������������������������������������������������6
9.1 Project design considerations & guidelines ������������������� 6
9.2 Recommended mounting and coverage specifications ����� 7
9.3 General installation instructions �������������������������������� 7
9.4 Locating the heater������������������������������������������������� 8
9.5 Minimum required clearances to surfaces and

combustibles �������������������������������������������������������� 8

9.6 Mounting the heater ����������������������������������������������� 8
9.7 Power supply ������������������������������������������������������� 10
9.8 Heat lamp replacement ������������������������������������������ 12
10. Appliance handover ������������������������������������������ 19
11. Specification ��������������������������������������������������� 19
11.1 Dimensions - CIR 150-1 I ����������������������������������������� 19
11.2 Dimensions - CIR 150-1 O & CIR 200-2 O ���������������������� 20
11.3 Dimensions - CIR 400-2 O ���������������������������������������� 20
11.4 Specification table ������������������������������������������������� 21
12. Spare parts ���������������������������������������������������� 21
13. What to do if... ������������������������������������������������ 21

WARRANTY AND CUSTOMER SERVICE
ENVIRONMENT AND RECYCLING

OPERATION

Advertising
This manual is related to the following products: