STIEBEL ELTRON SunWarmth CIR 400-2 O - Manual (Page 18)

18 |SUNWARMTH ™ CIR INFRARED HEATER WWW.STIEBEL-ELTRON-USA.COM
INSTALLATION
INSTALLATION
8. Slide lamp wires out of electrical connection box. Set electrical
connection box aside:
9. Remove interior end plate from heater: 6 Phillips screws fasten
the heater body end plate in place:
10. Slide top cover plates out each end of top side of heater:
11. Remove the center face plate:
» The BOTTOM edge of the center Face Plate does not have a
lower lip
» Insert a fine edged slot screw driver between the heater body
and the BOTTOM edge of the face plate
» Pry the face plate from the heater body, and remove to storage:
12. Slide the end face plates out from each end of the heater:
13. NOTE: For this step, keep the heat lamp retainer clips in place
at each end of lamps. Heat lamp is fragile - use caution when
feeding wires through holes.
» Carefully feed each lamp wire from the top of the heater through
the hole in the heater body so that the wire is inside the heater
body (same as the lamp):