Conair SC-5 - Manual (Page 50)

Next or Prev, Pressing Next selects the second Function Area.
Pressing Prev returns the display to the first Function Area
screen. Pressing Prev from the first Function Area screen
returns the display to the active main mode screen.
Menus are a convenient way to access and monitor parameters
that do not need to be altered often, i.e. blade speed, blade
count, cut mode, repeatability test, min. allowable measure-
ment and cuts per minute.
The most frequently used functions for a certain cutting mode
are directly available from the main screen for the active
mode. For a guide to screen navigation for any active mode
see the operator display overview section of this manual for
that mode. For information on the Blade and Parts Softkeys
see their respective sections covered earlier in this manual.
TEST SOFTKEY
Pressing soft key two located under the word Test on the first
Function area screen, selects the repeatability tester.
The DevCP repeatability tester displays total deviation time in
milliseconds. This time is from a cut being requested until the
blade reaches the part. The smallest measured value is sub-
tracted from the largest measured value and the resulting devi-
ation is displayed on the screen. New data is sampled every
consecutive cut. The DevCP repeatability test is available in
all on-demand modes. This test is used as a tool for verifying
the accuracy of the cutter.
On/Off Softkey1
On the display, on the lower left side is a soft key labeled On
or Off. Pressing this key while On is displayed will reset all
values and disable testing. Likewise pressing this key while
Off is displayed starts the test.
Reset Softkey3
On the display, on the lower right side is a soft key labeled
Reset. Pressing this key will reset all test values and start a
new test.
Exit or Prev, Pressing Exit, Prev or the Softkey under the
word Exit resets all values and disables testing then returns the
display to the Function area screen.
DevCP 000.000 mS >
Off Exit Reset
C
ONTROL
I
NSTRUCTIONS
T
EST
C
ONTROL
I
NSTRUCTIONS
F
UNCTION
A
REAS
C
ONTINUED
Continued
4-16
O
PERATION SC-5 SURE CUT Servo Knife Cutter UGE059/1003