Arnings and, Autions c – Conair SC-5 User Manual

Page 69

Advertising
background image

UGE059/1003

SC-5 SURE CUT Servo Knife Cutter

M

AINTENANCE

5-3

WARNING: Voltage Hazard

This equipment is powered by alternating cur-
rent, as specified on the machine serial tag and
data plate. Do not operate the equipment at
power levels other than what is specified on the
machine serial tag and data plate.

A properly-sized conductive ground wire from
the incoming power supply must be connected
to the chassis ground terminal inside the electri-
cal enclosure. Improper grounding can result in
severe personal injury and erratic machine
operation.

LOCKOUT/TAGOUT:
Before performing maintenance or repairs on
this product, disconnect and lock out electrical
power sources to prevent injury from unexpect-
ed energization or start-up. A lockable discon-
nect device has been provided to isolate this
product from potentially hazardous electricity.

DANGER: Sharp blades!

Most injuries caused by knife blades occur
when the cutter has been turned off. Handle
blades with care at all times.

●

Always wear cut-resistant gloves when the

cutting chamber is open and when handling
blades.

●

Always lock out the cutter before opening the
cutting chamber. (See Lockout/tagout above)

●

Always wait until the cutter head has stopped
completely before opening the knife guard.

SC-5 Sure Cut cutters are equipped with sever-
al safety devices to ensure safe operation.
Never remove or disable these devices to sus-
tain production. Operating without these devices
can cause severe injury.

●

When the knife guard is opened, the knife
guard switch stops the cutter but does not
remove powder from the drive.

●

Two proximity-type safety switches prevent
operation unless the cutter bushings are in
place.

●

The STOP button activates a circuit that
stops the knife.

W

ARNINGS AND

C

AUTIONS

C

ONTINUED

Advertising