Attention – Conair SC-5 User Manual

Page 8

Advertising
background image

In order to protect the operator from possible harm from the
rotating blade wheel, several safety features are built into this
cutter. They include:

Two electric switches make a contact between the side

and the clear polycarbonate sliding blade observation

windows such that the windows MUST BE CLOSED

in order to enable the blade wheel to spin.

●

●

This prevents someone from opening the windows and

having the blade wheel spin which can cause serious
injury. Tampering with this safety feature will VOID
ANY responsibility for safety.

A proximity switch is positioned on both the upstream

and downstream side of the bushing holder. If there
are no bushings in either side, the blade will not spin.

●

●

This prevents someone from inserting their hands or
fingers in the cutting mechanism while the blade wheel
is spinning. Tampering with this feature will also
VOID ANY responsibility for safety.

A safety switch is positioned on the bushing holder flip

up guard to prevent operation unless fully closed.

●

●

This prevents someone from inserting their hands or
fingers in the cutting mechanism while the blade wheel
is spinning. Tampering with this feature will also
VOID ANY responsibility for safety.

A lockable main power disconnect is provided to pre-

vent the possibility of hazardous electrical shock while

servicing the main electrical enclosure. (See How to
use the Lockout Device, in Section 1)

SC-5 SURE CUT Servo Knife Cutter

UGE059/1003

1-4

I

NTRODUCTION

WARNING: Voltage Hazard

This equipment is powered by three-phase
alternating current, as specified on the machine
serial tag and data plate.

A properly-sized conductive ground wire from
the incoming power supply must be connected
to the chassis ground terminal inside the electri-
cal enclosure. Improper grounding can result in
severe personal injury and erratic machine
operation.

Always disconnect and lockout power before
opening the electrical enclosure or performing
non-routine procedures such as maintenance
and service.

ATTENTION:

R

EAD THIS SO NO

ONE GETS HURT

CAUTION: It is always recommend
that the main power cord be dis-
connected and placed in clear view
of the operator or service person-
nel while changing blades or ser-
vicing the cutter in any capacity.

Advertising