360 Systems DigiCart/E - Manual (Page 28)

26
• Administration
6. Repeat 4 and 5 to create more groups if desired.
7. Click Apply at the top of the window.
8. In Windows Explorer, go to the net drive you want to set permissions for. Right-click on it and select
Properties.
9. Check to see that the Read Only attribute is unchecked. If so, click on it to remove the check mark.
10. Click on the NFS Sharing tab, and click
Permissions.
11. ALL MACHINES will normally be selected
by default, if not click on it to select it.
Click on Type of Access and select Read
Only or No Access from the pop-up list.
This defines the global permission for the
net drive. Note that this has no effect on
Windows file sharing permissions.
Click on Add to bring up the next screen.
12. Select the group or groups that are to have
Read/Write access to the net drive. Shift+click
and Ctrl+click allow selection of multiple
groups. Type of Access is Read/Write by
default. Click Add, then click OK.
13. If the global permission is No Access, click Add
in NFS Share Permissions and click on the pop
up menu to change Read/Write to Read Only.
Select any groups that you want to have Read
Only access.
14. Click Add, and then OK.
In the screen above, it is also possible to type the IP address of an individual DigiCart/E in the Add Names
field and click OK. This is useful when setting up personal drives that are to be accessed by only one or a few
units and you don’t want to define a group for them.