360 Systems Short/Cut Editor - Manual (Page 23)

Rear Panel Features Page 15
Shortcut Audio Editor Owner’s Manual
CHAPTER II
REAR PANEL FEATURES
All connections to the Shortcut Editor are made on the rear panel. Some connectors have
a dual purpose, and are explained in detail in the Recording or General Operations chapter.
OUT
IN
PROFESSIONAL DIGITAL AUDIO EQUIPMENT
ANALOG INPUT
LEFT
ANALOG OUTPUT
RIGHT RIGHT
MADE IN USA
LEFT
AES/EBU DIGITAL
IN OUT
115-230VAC, 50-60Hz
MODEL #
360 SYSTEMS, WESTLAKE VILLAGE, CALIFORNIA, USA
AES 75 OHM
CONTRAST
EXPANSION GPI 1.2A MAX
SERIAL #
O
I
REAR PANEL OF SHORTCUT EDITOR
Analog Audio Inputs and Outputs
Analog inputs and outputs are provided on balanced XLR connectors at a nominal level
of +4 dBu. Pin 2 is +, pin 3 is –, pin 1 is shield.
Microphone Preamplifier and Gain Switch
A microphone may be connected to the left channel XLR input connector. A push
button switch next to this connector inserts a microphone preamplifier having a gain of 40 dB.
This signal is recorded on the left channel only. The right channel can be used with a line level
signal simultaneously. This is designed for a dynamic microphone; no phantom power is
provided.
Digital Audio Inputs
A female XLR-3 connector accepts inputs in the AES/EBU format. A BNC connector
accepts inputs in either the consumer IEC-958/II format or the 75-ohm AES3-ID format.