360 Systems Short/Cut Editor - Manual (Page 43)

Editing Page 35
Shortcut Audio Editor Owner’s Manual
EDIT OUT MARK EDIT IN MARK
Diagram 1: Selection to be Cut is Marked
Diagram 2: Selected Audio is Removed and Remaining Audio is Spliced Together
CROSSFADE TIME
THE RESULTING FILE IS
SHORTENED BY AN AMOUNT
EQUAL TO THE CROSSFADE TIME
Diagram 3: Spliced Audio is Overlapped and Crossfaded Between the Two Parts
Performing a Crossfade Only Cut
Performing a Cut with Crossfade when the Edit In and Edit Out Marks are in the same
place will generate an error message in the top line of the display,
“ * NOTHING TO CUT * ”
followed by
“APPLY CROSS FADE? (YES=ENTER, NO=EXIT)”
Pressing E NTER causes the material on either side of the Edit Marks to be crossfaded by
the amount of time set for the Crossfade Time. This process is effectively illustrated by
diagrams 2 and 3 above. The Run Time of the file is reduced by the Crossfade Duration.