Checkline YSL-2000HD - Manual (Page 6)

6
5 .0 I N STALLI N G BAT T ERI ES
1. Turn the gauge over and locate the battery
compartment. You do not have to remove
the rubber shell.
2. Open the battery compartment by pulling
down on the tab located at the top of the
battery cover and remove the cover.
Insert two AA batteries following the
orientation engraved on the inside of the
battery compartment.
3. Replace the battery cover by inserting the
two tabs located on the bottom edge of the
cover into the matching slots in the housing.
4. Push the cover closed until the tab at the
top of the battery cover “clicks” into a
locked position.
5. Replace the cut-out section of the protective
rubber shell.
click
11
9 .0 M EASU RI N G RPM
9.1 Contact Operation - RPM
1. Install the Slide-on Contact Adapter.
Push on securely
2. Slide the Cone Tip adapter over the shaft of
the instrument. Be sure to align the pin on
the side of the shaft with the slot in the
adapter. Push on securely.
3. Select the Contact RPM mode by pressing
the MODE key until the rpm symbol appears
in the top left corner of the LCD display
4. Position the adapter carefully so that it contacts the center of
the rotating shaft. Apply enough pressure to eliminate any slip.
5. Press and hold the MEASURE key to take measurements.
6. Release the MEASURE key prior to removing the instrument from
the rotating element. The LAST reading will be retained on the
display.
MO
D E
M EM
ma x m in mem
rp m m /min ft/m in in /m in
8.8.8.8
.8
SLOT
PIN
RPM