Checkline YSL-2000HD User Manual
Page 8
8
6. Insert the filament between the outer
“wrapper” roller and measuring wheel
letting it contact the flat surface on the
top of the Wrapper Roller Arm. Rotate
the instrument counter-clockwise
approximately 90 degrees (1/4 turn).
The filament should run through the
groove of both rollers. Keep the
instrument steady, avoiding any
disturbance of the filament path.
7. Press and hold the Measure key to take measurements.
8. Release the Measure key prior to removing the instrument
from the moving filament. The last reading will be retained on the display.
Refer to Memory System Section 10.0 for details on using the built-in
memory.
7 .0 M EASU RI N G SU RFACE SPEED OR LEN GT H
1. Install the Slide-on Contact Adapter.
2. Slide the Surface Speed Wheel over the shaft of the
instrument. Be sure to align the pin on the side of the
shaft with the slot in the adapter. Push on securely.
NOTE:
If using optional surface speed wheel,
refer to Section 8.0 before continuing.
3. Select the desired units of measure
for surface speed or length by
pressing the MODE key until the
appropriate symbol appears on the
LCD Display.
The units of measure appear in
the following sequence:
RPM➔ m/min ➔ m/sec ➔ ft/min ➔ ft/sec ➔ in/min ➔ m ➔ ft ➔ in
4. Position the wheel carefully so that it is
perpendicular to the moving surface. Apply
enough pressure to eliminate any slip.
5. Press and hold the MEASURE key to take
measurements.
6. Release the MEASURE key prior to removing the instrument from
the moving surface. The Last reading will be retained on the display.
9
MODE
MEM
max
m
in
mem
rp
m
m
/m
in
ft/min
in/m
in
8.8.8.8
.8
PIN
SLOT