Checkline YSL-2000HD - Manual (Page 7)

7
6 .0 M EASU RI N G YARN /WI RE SPEED & LEN GT H
1. Install the Slide-on Measuring Head for
Yarn/Wire Speed& Length.
2. Select the desired units of measure for
speed or length by pressing the MODE
key until the appropriate symbol is
shown on the LCD display.
Speed Length
feet/min feet
meters/min meters
inches/min inches
3. Press MEM and MODE keys simultaneously
& release. The currently selected wheel size
will show in the display. Refer to fig. A.
4. Change this setting to 0.1 to match the
wheel being used for measuring yarn
rate/speed by pressing the MODE key.
Each time the MODE key is pressed,
the wheel type will change as follows:
6" ‘ 0.1 ‘ 12" and repeat
5. When 0.1 is shown on the display, press
the MEASURE key to select.
Refer to fig. B.
MODE
A
B
10
8 .0 U SI N G OPT I ON AL-SI Z ED SU RFACE SPEED WH EELS
The following wheels can be used with the YSL-2000HD
8.1 Setting Wheel Size
1. Press MEM and MODE keys
simultaneously & release. The
currently selected wheel size will
show in the display
2. Change this setting to match the wheel
being used by pressing the MODE key.
Each time the MODE key is pressed,
the wheel type will change as follows:
6" ➔ 0.1 ➔ 12" and repeat
3. When the correct size is shown on the
display, press the MEASURE key to
select.
NOTE: Factory default setting for wheel
type is 6". If wheel type is changed, the
new setting is retained in memory. When
batteries are changed, wheel type setting
will revert to factory default.
Optional
12" Wheel
Optional
0.1 Meter Wheel
Standard
6" Wheel
1.9"
(49mm)
1.2"
(32mm)
3.8"
(97mm)
NOTE: Factory default setting for wheel
type is 6". If the wheel type is changed, the
new setting is retained in memory. When
batteries are changed, wheel type setting
will revert to factory default.