Cub Cadet I-Beam Style - Manual (Page 158)

5-19
5
b. Lift belt out of sheave of bottom pulley.
c. Slide belt out of bottom of chain case.
d. Install new belt.
7. Remove drive belt as follows:
a. First slip auger drive belt off engine pulley.
See Figure 5-21.
b. Slip drive belt over double engine pulley.
c. Slide belt off bottom pulley and out of bot-
tom of chain case.
d. Install new drive belt.
e. Reinstall auger drive belt.
8. Reassemble by reversing steps 1 through 7.
9. Remove plastic film from gas cap.
CAUTION
Check engine and snow thrower frequently for
loose nuts, bolts, etc., and keep these items
tightened.
5-3.1 Model Specifications. For a summary of
specifications for these models, see Table 5- 2.
5-3.2 Shift Rod Adjustment. Refer to Model 225 in
paragraph 5-2.3.
SNOW THROWER.fm Page 19 Wednesday, February 20, 2002 10:28 AM