Freerider FR510GDX(Westminster) - Manual (Page 23)

23
A plug with bared flexible cord is hazardous if
engaged in a live socket outlet.
4. Always handle batteries carefully, they are heavy, it may
require two people for lifting. Wear protective gloves and
glasses when handling.
5. Dispose of worn out batteries carefully, contact your local
waste disposal authority.
Your Charger's main input cord is already fitted with a moulded
plug incorporating a fuse, the value of which is indicated on the
pin face of the plug. Should the fuse need to be replaced, an
ASTA approved Bs1362 fuse must be used of the same rating.
If the plug supplied is not suitable for your socket outlet, it
should be cut off and destroyed
.The end of the flexible cord
should be suitably prepared and the correct plug fitted. If any
other type of plug is used a 5amp fuse must be fitted either in
the plug, adaptor or at the distribution board.
CHARGER MAINS PLUG
WARNING:
CHARGER MAINS PLUG
WARNING:
Remove salt
contact as this is very corrosive to bright metal parts.
BODYWORK
Caution:
A damp cloth and a little soapy water will keep your seat,
backrest and arms looking smart. Do not use abrasive
cleaners as this will damage the coating. Upholstery can be
damaged by chemical cleaners. The coating material can also
degrade over a period of time due to contamination by
natural oils in the hair and skin.
Ultra-violet light can also reduce the life of the upholstery
coating material. This is a normal ageing process and cannot
be guaranteed (see exclusions in the Guarantee Terms).
The painted bodywork on your Scooter can
be lightly washed with clean soapy water. Do not use
abrasive cleaners or strong detergents. This could fade the
colour, an auto tyre shampoo works well.
Note: Only competent people should carry out service work.
Westminster
Westminster Do not hose down your with a powerful
cs and cause
permanent damage.
On the painted finish, be cautious not to wash with a dirty
cloth as this could scratch the paint finish. Auto polish can
be used to keep the paintwork and bright chrome parts in
pristine condition.
SEAT UPHOLSTERY
cleaner. Water could be forced into the electroni
Note: Only competent people should carry out service work.
SEAT UPHOLSTERY
BODYWORK
Westminster
Westminster Caution:
CARE & MAINTENANCE
Important: The wires in the mains lead are coloured in
accordance with the following code: Blue-neutral, Brown-live
As these colours may not correspond with the coloured
markings identifying the terminals in your plug, proceed as
follows: The wire which is coloured Blue must be connected to
the terminal in the plug which is marked with the letter N or
coloured Blue or Black. The wire coloured Brown must be
connected to the terminal which is marked with the letter L or
coloured Brown or Red.
Do not connect either wire to the earth terminal
which is marked with the letter E, by the earth symbol or
coloured green or green/yellow.
Fittings marked are double insulated and do not
need to be earthed. If in doubt or difficulty is experienced,
consult a qualified electrician.
PLUG WIRING INSTRUCTIONS
Warning:
Caution:
PLUG WIRING INSTRUCTIONS
Warning:
Caution:
Your like any other electro-mechanical machine
will benefit from regular servicing by your dealer.
You too, can help keep your in tip-top condition
by following a simple guide to home maintenance.
Westminster
Westminster
Freerider
Westminster
Westminster
Freerider
Servicing of the drive electronics and charger should only be
carried out by your local
service dealer. These
units are sealed and should not be opened.
Freerider
BROKEN
SEALS WILL INVALIDATE YOUR GUARANTEE.
Westminster
Westminster
The motor on your is fitted with
long-life brushes. The brushes should be inspected for
wear every 12 months or more frequently if you use you
Westminster daily for long periods. The brushes should be
changed when they have worn down to approximately
8mm in length.
Freerider Westminster
ELECTRONICS
MOTOR
Do not operate your Freerider in exceptional
weather conditions i.e. very heavy rain or wind. Cover
your machine up, if it is to be left unattended and outside
for a long period of time.
Do not drive through deep water with your .
This could damage the electronic speed controller. Sea
and road salts are very corrosive and should be
neutralized quickly.
ELECTRONICS
Freerider
Do not operate your Freerider in exceptional
weather conditions i.e. very heavy rain or wind. Cover
your machine up, if it is to be left unattended and outside
for a long period of time.
BROKEN
SEALS WILL INVALIDATE YOUR GUARANTEE.
Westminster
Do not drive through deep water with your Westminster.
This could damage the electronic speed controller. Sea
and road salts are very corrosive and should be
neutralized quickly.
MOTOR
Freerider Westminster
The metal framework of your should be
cleaned twice a year and any paintwork damaged should be
treated to prevent further attack from the elements. Wash
regularly if contact is made with road or sea salt, this is very
corrosive.
store your in damp conditions. This
may affect the electronics if left for very long periods of
time. Moisture, if left unattended can cause deterioration on
metal work, protect with proprietary cleaners.
Westminster
Westminster Do not
Westminster
Westminster Do not