Freerider FR510GDX(Westminster) - Manual (Page 8)

8
stop brackets situated on the lower part of the backrest,
failure to observe this warning may distort the backrest
frame.
The rearward stability of your Scooter will
be reduced the greater the backrest angle is set past 90
Always take great care when going up steep slopes or kerbs,
always lean forwards to achieve the best stability for your
Scooter.
The upper cushion of your
backrest (See Fig 8) can be adjustment for height, giving
you more back support if you are tall, by operating the
small latch at the base of the left hand round support bar.
Lift the cushion up or push down for the most comfortable
position. The headrest will also lift out for convenience.
Your seat is fitted with a
safety belt to prevent you from slipping forwards under
braking conditions or when going sown a slope or over
obstacles, always us it-even for short journeys.
The lap belt can be adjusted on one side to fit comfortably
around your waist. To fit simply connect the two buckles
together( see fig 9 )until a distinct 'click' is heard. To
remove simply 'press' the red buckle and the two belts will
separate.
Care should be taken when the belt is
not in use, it should be connected together and placed in
the centre of the seat cushion. Failure to observe this notice
could lead to the two buckles falling onto and damaging the
bodywork, catching a person or foreign body.
The handlebar of your is designed to allow you to
position it in a comfortable driving position. It can be locked
into numerous positions or unlocked to move freely for
transportation.
The handlebar lock is operated by a black lever positioned on
the right hand side of the handlebar (see Fig 10). To release
the handlebar from a locked position pull the black lever
upwards, the handlebar will now move freely, but under mild
tension.
To lock the handlebar into a comfortable driving position,
simply push the black lever downwards until the handlebar is
locked firmly into position.
With the combination of the height adjustment together with
the handlebar movement, you should find a suitably
comfortable driving position.
Always make certain the handlebar locking lever is
fully down and the handlebar is securely clamped onto the
chrome support plates before driving your Scooter. For service
adjustment of this part, refer to the Care and Maintenance
section of this manual.
Your controls are located on the handlebar console (see
Fig11) they are:
This allows you to pre-select
you desired top speed. The dial is proportional to speed
and can be set anywhere between 'min' and 'max' increments.
Turn the dial knob anti-clockwise to minimum for a very
7. Backrest Height Adjustment:
1. Speed Adjustment Dial:
Westminster
Westminster
Warning:
Caution:
8. Lap Safety Belt:
HANDLEBAR ADJUSTMENT
Warning:
CONTROL FEATURES
Warning:
Caution:
HANDLEBAR ADJUSTMENT
7. Backrest Height Adjustment:
8. Lap Safety Belt:
1. Speed Adjustment Dial:
Westminster
Westminster
Warning:
CONTROL FEATURES
FIG 8
FIG 9
FIG 10
On-Off
Power
Switch
5
Battery
Meter
Status
Indicator
Hazzard
WIIarning
4/8mph
Speed
Switch
74
6 3
Horn
Direction
Indicator
Light Switch
9 10 2
Front/Rear
Light Switch
FIG 11
Speed
Adjustment
Dial 1
6
Diection
Warning
Lights Diection
Warning
Lights
7
8
Lo-Speed
Warning
Light