FRITSCH PULVERISETTE 1, Model I premium line - Manual (Page 9)

The final fineness that can be achieved is between about 15 mm and 0.3
mm, depending on the setting.
The Jaw Crusher described here is an equipment item for applications in
industrial environments.
The device may only be used for this purpose.
2.2.1 Operating principle
The materials are crushed in a crushing chamber, created by two support
walls (11), an adjustable, fixed crushing plate (17) and a swinging, mov-
able crushing plate (21). The movable crushing jaw (12) is driven by a fly-
wheel. Due to its special motion sequence, the material to be crushed is
pulled into the crushing chamber and the crushed material is protected
from getting jammed. This material exits the crushing chamber through
the adjustable discharge gap and is collected in the source material con-
tainer (8).
2.3 Obligations of the operator
Before using the PULVERISETTE 1 premium line, this manual is to be
carefully read and understood. The use of the PULVERISETTE 1 premium
line requires technical knowledge; only commercial use is permitted.
The operating personnel must be familiar with the content of the oper-
ating manual. For this reason, it is very important that these persons
actually receive the present operating manual. Ensure that the operating
manual is always near the device.
The PULVERISETTE 1 premium line may exclusively be used within the
scope of applications set down in this manual and within the framework
of guidelines put forth in this manual. In case of non-compliance or
improper use, the customer assumes full liability for the functional capa-
bility of the Jaw Crusher and for any damage or injury arising from failure
to fulfil this obligation.
By using the PULVERISETTE 1 premium line the customer agrees with this
and recognizes that defects, malfunctions or errors cannot be completely
excluded. To prevent risk of damage to persons or property or of other
direct or indirect damage, resulting from this or other causes, the cus-
tomer must implement sufficient and comprehensive safety measures
for working with the PULVERISETTE 1 premium line.
Neither compliance with this manual nor the conditions and methods
used during installation, operation, use and maintenance of the PUL-
VERISETTE 1 premium line can be monitored by Fritsch GmbH. Improper
execution of the installation can result in property damage and thus
endanger persons. Therefore, we assume absolutely no responsibility or
liability for loss, damage or costs that result from errors at installation,
improper operation or improper use or improper maintenance or are in
any way connected to these.
The applicable accident prevention guidelines must be complied with.
Safety information and use
- 9 -